Xmas Toy ( TA project) come early

Using TA as work bench very bad lol.🤣 Hope to start work on it soon. Did the oil on supercharger engine oil check other fluids and greased all the nipples 14 of them
IMG_20250517_095402.jpg
IMG_20250517_095334.jpg
IMG_20250517_095321.jpg
IMG_20250408_164756.jpg
 
Well that went better than expected so far, used camera function on autel scan tool no old gasket left on head or manifold so that good the bolts are in rough shape some of the threads not right cleaned the far right one up re died it 3/8 curse thread with 7/17 head for spanner, then on wire brush on bench grinder , do i change over to new stud and nut in stead of bolts???? can be seen been blowing for some time black sooted up gasket and bolt threads didnt use ramp as if job went pear shaped the heads would of needed to come of didnt want to tie the ramp up so 2 rear bolts access through wheel arch ,

IMG_20250604_112742.jpg
IMG_20250604_112415.jpg
IMG_20250604_112406.jpg

IMG_20250604_122736.jpg
IMG_20250604_122856.jpg
IMG_20250604_122812.jpg
IMG_20250604_122740.jpg
IMG_20250604_124728.jpg
IMG_20250604_124746.jpg
 

Attachments

  • IMG_20250604_122740.jpg
    IMG_20250604_122740.jpg
    2.5 MB · Views: 1
Last edited:
Did you get to use your new 'heating up bolts' tool?
 
No I didn't order one in the end 1st bolt easy 2nd tight 3rd tight 4th very tight and pig to get to 5th easy. Wonder wat other side will be like??? Very suprised to be honest looking at how rusty they were
 
Back
Top